3t10K-HVES-G5 Wiring | EPSherpa Documentation

This page describes the communication with a Solis 3T10K over Modbus-RTU (rs485). By default, the inverter is set to address 1. This can be changed via the display of the inverter. You can find the procedure in chapter 7.3.2 of the manual. The RS485 terminals are located on the bottom of the inverter behind a protective plate.

RS485 Wiring

For correct RS485 wiring: follow the RS485 wiring guidelines.
If the wiring shown in the table below is incorrect, please let us know.
There is no general industry consensus on the use of A and B for RS485 polarity, so the naming may be counterintuitive for some devices.

Device	EPSherpa EMS model OM1	EPSherpa EMS model IG8	RS485-USB converter	RS485-Ethernet converter
Pin 3	RS485 A	RS485_POS	RS485 A	TX+
Pin 4	RS485 B	RS485_NEG	RS485 B	TX-
N/A	RS GND	GND	Not available	G

NOTE: RS485 Device Addresses

You MUST give each device a unique address on the RS485 bus. Check the device manual for instructions.
Use lower addresses first (1, 2, ...) because the EPSherpa EMS will find them faster!
For each device, it is generally recommended to keep the factory-default baud rate, parity, and stop bits. The EPSherpa EMS will scan those first.

Last updated August 24, 2026

RS485 Wiring

For correct RS485 wiring: follow the RS485 wiring guidelines.
If the wiring shown in the table below is incorrect, please let us know.
There is no general industry consensus on the use of A and B for RS485 polarity, so the naming may be counterintuitive for some devices.

Device	EPSherpa EMS model OM1	EPSherpa EMS model IG8	RS485-USB converter	RS485-Ethernet converter
Pin 3	RS485 A	RS485_POS	RS485 A	TX+
Pin 4	RS485 B	RS485_NEG	RS485 B	TX-
N/A	RS GND	GND	Not available	G

NOTE: RS485 Device Addresses

You MUST give each device a unique address on the RS485 bus. Check the device manual for instructions.
Use lower addresses first (1, 2, ...) because the EPSherpa EMS will find them faster!
For each device, it is generally recommended to keep the factory-default baud rate, parity, and stop bits. The EPSherpa EMS will scan those first.

Last updated August 24, 2026