If you reset the EPSherpa EMS, the network configuration will be reset to DHCP. Take care if you perform a factory reset remotely, because the EPSherpa EMS might lose network access if it needs a specific network configuration!
Before you perform a factory reset, it is recommended that you make a backup of the settings.
Lost access to commissioning interface You can retrieve the IP address through mDNS. See also Option 3.2 of Accessing the commissioning interface.
You can reset the EPSherpa EMS through the commissioning interface, from the settings tab. Scroll down to "Factory reset", and click "Factory reset".
Switch on the EPSherpa EMS and wait until it has booted (the status LED turns green). This can take several minutes without internet. Then reset it with the physical reset button in the pin hole next to the RS485 interface:
If you release the button before the status LED turns red, nothing is reset.
Make sure you feel the reset button clicking when pressing it.
This model does not have physical reset button. You must reset the EPSherpa Controller through the commissioning interface.
This model does not have physical reset button. You must reset the EPSherpa Controller through the commissioning interface.
Switch on the EPSherpa EMS and wait until it has booted (the status LED turns green). This can take several minutes without internet. Then reset it with the reset button in the pin hole next to the DC IN connector:
If you release the button before the status LED turns red, nothing is reset.